User Manual

Application class Standard Drive Control Dynamic Drive Control
Motors that can be
operated
Induction motors Induction, synchronous and reluctance motors
Commissioning
● Unlike "Dynamic Drive Control," no speed
controller needs to be set
● When compared to "Expert":
– Simplified commissioning using
predefined motor data
– Reduced number of parameters
● "Standard Drive Control" is preset for Power
Modules, frame size A … frame size C
● Reduced amount of parameters when
compared to "Expert"
● "Dynamic Drive Control" is preset for Power
Modules frame size D … frame size JX
5.4.3.2 Standard Drive Control
Select the motor standard:
● KW 50HZ: IEC
● HP 60HZ: NEMA
● KW 60HZ: IEC 60 Hz
Set the inverter supply voltage.
Select the motor type. If a 5-digit motor code is stamped on the motor rating plate, select the
corresponding motor type with motor code.
Motors without motor code stamped on the rating plate:
● INDUCT: Third-party induction motor
● 1L… IND: 1LE1, 1LG6, 1LA7, 1LA9 induction motors
Motors with motor code stamped on the rating plate:
● 1LE1 IND 100: 1LE1 . 9
● 1PC1 IND: 1PC1
● 1PH8 IND: Induction motor
● 1FP1: Reluctance motor
Depending on the inverter, the motor list in BOP-2 can deviate from the list shown above.
If you have selected a motor type with motor code, you must now enter the motor code. The
inverter assigns the following motor data corresponding to the motor code.
If you do not know the motor code, then you must set the motor code = 0, and enter motor
data from p0304 and higher from the rating plate.
87 Hz motor operation The BOP-2 only indicates this step if you selected IEC as the motor
standard (EUR/USA, P100 = KW 50HZ).
Rated motor voltage
3
(8586$
3
,1992/7
3
0277<3(
3
027&2'(
+=
3
02792/7
Commissioning
5.4 Quick commissioning using the BOP-2 operator panel
Converter with the CU230P-2 Control Units
168 Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257946B AF