User's Manual

Siemens PLT 111 · 1999
4/8
I/O modules
Proportioning counter module,
metering pulse input module
Proportioning and counter modules
Counter modules
Two counter modules are available:
• Proportioning counter module with 2 or 4 channels,
6DS1 613-8BB
For counting and largely autonomous processing of metering
pulses, independent of the superimposed automation system.
The module can be used for
– proportioning,
– measuring rotational speed and velocity,
– measuring lengths and
– counting pulses.
• Metering pulse input module with 8 channels,
6DS1 607-8AB
Input and addition of 8 metering pulses from contacts or BERO
proximity switches with transmitter supply from the module
(non-floating).
Ordering data
Proportioning counter module
with 2 or 4 channels
– Module
– German Instruction Manual
– English Instruction Manual
6DS1 613-8BB
C79000-B8000-C46
C79000-B8076-C46
Metering pulse input module,
with 8 channels
– Module
– German Instruction Manual
– English Instruction Manual
6DS1 607-8AB
C79000-B8000-C45
C79000-B8076-C45
Configuring
STRUK-AS 220 EA configuring program
STRUK-AS 220 EA can be used to configure the configurable
I/O modules on a programming device/PC (with MS-DOS oper-
ating system). The programming device/PC must be connected
• via a built-in TTY interface and the cable 6DS8 170-8AD to the
TTY interface of the I/O module (direct coupling)
or alternatively
• integrated via a local bus interface module N-AT and a cable
for 20-m local bus into the CS 275 plant bus (central coupling).
Special requirements for module configuring via the CS 275
plant bus:
• AS 235 system software version G.1 or later
• Vacant user memory (RAM) at least 300 byte (memory is made
available again following configuring).
The complete configuration including all application parameters
can be stored on diskette and thus loaded into a replacement
module if necessary. New settings, and the associated possibil-
ity of making mistakes, are therefore unnecessary. The replace-
ment module is immediately ready for use.
Ordering data Order No.
Coding, inserting and labelling
The I/O modules can be supplied coded, inserted and with
labelled slots. Arrangement, designation and connection dia-
grams (including address data) are required from the orderer.
Ordering data Order No.
STRUK-AS 220 EA program
German/English
6DS5 221-8AX
STRUK-AS 220 EA User’s Guide
– German
– English
C79000-G8000-C310
C79000-G8076-C310
Direct coupling
Cable
to connect a configurable I/O
module to a personal computer,
10 m long
6DS8 170-8AD
Central coupling
Hardware coupling package
to couple a PC to CS 275, com-
prising interface module N-AT,
cable for 20-m local bus and
Instruction Manual in
– German
– English
6DS1 222-1BA10
6DS1 222-1BA20
Coding, inser ting and labelling
for 1 I/O module
6DS5 705-8AA
This catalog is out of date, see note on page 1