User's Manual

Diagnostics via AS-Interface
7.3 Telegrams
ASIMON V3 - Configuration software for AS-Interface safety monitor
172 Programming and Operating Manual, Edition 09/2008, GWA 4NEB 333 1558 02 DS 02
7.3.2 Diagnosis of devices, sorted by OSSD
With the appropriate configuration setting, data calls (4) … (B) return device diagnostic infor-
mation sorted according to output circuit.
Sorted device diagnosis, output circuit 1
If answer to data call (1) = 10X1:
Note
Make sure that the correct diagnosis type is set for the AS-Interface safety monitor in the
Information about monitor and bus window of the ASIMON configuration software.
The values returned in calls (5) and (6) as well as (9) and (A) refer to the device diagnosis index
in the configuration program and not to an AS-Interface address.
Always execute data calls (4) … (7) and (8) … (B) together in sequence for each device.
Data call / Value Answer
D3 … D0
Meaning
(4) / 1011
Number of devices
not green, output
circuit 1
0XXX XXX = 0:
XXX = 1 … 6:
XXX = 7:
no devices, answers to data calls (5) … (7)
not relevant
number of devices in output circuit 1
number of devices is > 6 in output circuit 1
Data call / Value Answer
D3 … D0
Meaning
(5) / 1010
Device address
HIGH, output
circuit 1
1HHH HHH = I5,I4,I3: diagnosis index of device in output circuit 1 of
configuration
(HHHLLL = diagnosis index)
Data call / Value Answer
D3 … D0
Meaning
(6) / 1001
Device address
LOW, output
circuit 1
0LLL LLL = I2,I1,I0: diagnosis index of device in output circuit 1 of
configuration
(HHHLLL = diagnosis index)
Data call / Value Answer
D3 … D0
Meaning
(7) / 1000
Colour of device,
output circuit 1
1CCC CCC = Farbe colour (see Table 7-1 on page 171)