User's Manual

Configuring the AS-Interface safety monitor
4.3 Creating and changing a configuration
ASIMON V3 - Configuration software for AS-Interface safety monitor
Programming and Operating Manual, Edition 09/2008, GWA 4NEB 333 1558 02 DS 02
135
Activating devices
In order to reactivate a deactivated device, click the right mouse button on the deactivated de-
vice. The following pop-up menu opens.
Select the Activate command. The device is again displayed as a full-colour image.
The safe address is reset to "safe" upon activation in the bus information and marked as used
in the configuration. This is represented by greyed-out fields and a check mark which cannot
be deselected in the "Safe" column.
If the safe address of the deactivated device was removed from the bus information during de-
activation, it is first re-registered.
If, in the meantime, the address in question was assigned to a different, newly configured de-
vice, an address conflict may result. In this case, the input window of the device which is to be
activated appears together with an info window which is attached to the edge of the window.
Select either a different safe address from those which are available or ensure (after cancelling
activation) that the address of the deactivated device is again available.