Installation guide

Mounting
13
Siemens Building Technologies
Fire Safety & Security Products 09.2008
5.4 Mounting the Camera Housing Assembly
The housing has a set of 4 x M6 x 10 mm deep tapped holes on a 101.6mm (4”)
PCD for mounting the camera housing to a bracket. Ensure the screws used to
mount the housing to a bracket do not bottom out in the mounting holes by being
too long.
1. Screw the mounting bracket to the base of the unit (A) (see
Fig. 6).
2. Secure the assembly following the bracket installation instructions.
Fig. 6 Mounting the Camera Housing Assembly