Installation guide

Mounting

Siemens Building Technologies

Fire Safety & Security Products 09.2008

5 Mounting

5.1 Adjusting the Sunshield

1. Firmly squeeze (A) the sides of the sunshield (See Fig. 3).

2. Slide (B) the sunshield to the required position.

3. Release the sunshield and it will remain in position.

Fig. 3 Sunshield adjustment

5.2 Accessing the inside of the Housing Enclosure

1. Using the ALLEN key provided, loosen but do not completely remove the

4 securing screws (A) (See

Fig. 4).

2. Slide the housing cover forwards (B).

3. Disconnect the earth wire from the terminal board (C).

4. Allow the cover to pivot at the end or twist to completely remove (D).

NOTE

To re-assemble carry out steps 1 to 4 in reverse, making sure the earth wire is reconnected. The

screws which secure the housing to the rear cap should be retightened to a torque of 2 Nm.

Fig. 4 Inside the housing enclosure

1 Rear End Cap