Technical data

65
Siemens Building Technologies
Fire Safety & Security Products 08.2006
12.5.3 VCL protocol
NOTE
RS485 connection; 9600 baud, no parity, 8 data bits, 2 stop bits.
Camera addressing is 0-127 for cameras 1-128.
Tested using Honeywell HKJMSTP-00 keyboard and HMAX081-00 matrix.
Operation User action Notes
Pan / Tilt /Zoom / Focus Joystick for Pan/Tilt/Zoom,[FN] / [FF]
for Focus
When in OSD cursor mode Pan / Tilt operate as cursor right / left /
up / down (but see also Recall Preset 1 below).
Iris [IRIS+] / [IRIS -] Only operates when exposure priority is set to KEYBOARD.
AutoIris On [AUTOIRIS] Overridden automatically on a manual iris operation.
AutoFocus On [FOCUS AUTO]
AutoFocus Off [FN] or [FF] Manual control overrides autofocus.
Day Mode / Night Mode [AUX] Toggle action. Switches camera between day and night modes
(colour/mono version only). It is not possible to indicate the current
state on the keyboard.
One-Touch White Balance [IRIS -] If one-touch white balance is enabled in OSD and exposure priority
is not set to KEYBOARD.
Recall Preset [n] [PRESET] or use one of [PRESET
1], [PRESET 2], [PRESET 3],
[PRESET 4]
Range 1-99.Preset 95* or Preset 2* twice within 2 seconds functions
as the OSD Mode 'MENU' command. When in OSD mode Preset 1
switches the joystick between cursor and camera control. When in
OSD cursor mode Preset 3 operates as SET.
Start Preset Tour [1] [AUTOPAN] Starts Tour 1.
Save Preset hold [PRESET], press [n], release
[PRESET]
Range 1-99.
Enter OSD Menu Mode [9] [5] [PRESET] or [PRESET 2]
[PRESET 2] within 2 seconds
Recall Preset 95* or Recall Preset 2* twice within 2 seconds
functions as the OSD Mode 'MENU' command.
Navigate OSD Menu Mode Joystick for Up/Down/Left/Right.
[PRESET 3] for Set.
When in OSD mode Recall Preset 1 switches the joystick between
cursor and camera control. When in OSD cursor mode Recall
Preset 3 operates as SET.
* The presets used to access the OSD are programmable via the XTU.
12.5.4 Videmech Universal protocol
NOTE
RS485 connection; 9600 baud, odd parity, 8 data bits, 1 stop bit.
Camera addressing is 1-254 for cameras 1-254. Also responds to broadcast address 255.
Tested using Videmech Vertex keyboard.
Operation User action Notes
Pan / Tilt / Zoom / Focus Joystick for Pan/Tilt, [ZI] / [ZO] for
Zoom, [FN] / [FF] for Focus
When in OSD cursor mode Pan / Tilt operate as cursor right / left /
up / down (but see also Recall Preset 1 below).
Iris [IO] / [IC] Only operates when exposure priority is set to KEYBOARD.
AutoFocus On [AUX 1] on
AutoFocus Off [AUX 1] off
Night Mode [LAMPS] on Lamps on switches camera to night mode (colour/mono version
only).
Day Mode [LAMPS] off Lamps off switches camera to day mode (colour/mono version only).
One-Touch White Balance [IC] If one-touch white balance is enabled in OSD and exposure priority
is not set to KEYBOARD.