Technical data

Siemens Building Technologies

Fire Safety & Security Products 08.2006

1 Compression Clamp

2 Plastic Washer

3 Connector Body

4 Cat 5 Cable Assembly

5 Rubber Washer

6 Locking Nut

1. Ensure that the connector is assembled as per the overview below. Ensure

that the locking nut is sufficiently tight to seal the assembly. Full assembly

instructions can be found in the Installation Manual.

2. Ensure that Seal 1 is present and fitted correctly.

3. Ensure that Seal 2 is present and fitted correctly.

4. Remove the Label adhered to the Solaris™ connector.

5. Make the connection.

6. Ensure that the spring-clip securely fastens and locks the connector to the

Solaris™ Dome.

Î This will ensure that Solaris™ is waterproof

8.5.1 Assembly

1. Pass the connector locking nut over the RJ45 plug.