Instruction manual

General Information

Siemens Building Technologies

Fire Safety & Security Products 03. 2005

1 General Information

1.1 General Safety Precautions



Read these instructions carefully before connecting the camera in order to avoid

damage caused by improper installation or use.

 Installation may be done only by authorized personnel according to the local

safety regulations.



Operate the camera only with the designated voltage.



Follow the safety instructions for the camera.

 Never use the camera for purposes other than those designated.

 Repairs and adjustments to the camera may be done only by authorized

personnel.



If liquids or objects get into the housing, disconnect the camera from the power

supply and have it checked by your authorized dealer before using it again.

(Danger of electric shock!)



This equipment has been tested and found to comply with the limits for a Class

B digital device. These limits are designed to provide reasonable protection

against harmful interference in a residential installation.



This equipment may generate, uses and can radiate radio frequency energy

and, if not installed and used according to instructions, may cause harmful

interference with radio communications.

 Be aware that any modifications not explicitly approved in this manual may void

your equipment warranty.



The shielded interface cable recommended in this manual must be used with

this equipment in order to comply with the limits for a digital output device.

1.2 Electromagnetic Compatibility (EMC)

This product has been designed for use in general-purpose CCTV applications in a

residential, business or industrial environment. Please contact the supplier of this

product before you install it in medical and/or intrinsically safe applications or in an

industrial EMC environment.

To ensure normal operation and to avoid EMC problems, the product must be

installed according to the currently valid EMC installation guidelines.

To meet the CE norms, enclosed EMI-cores should be applied to the Y/C and

power cable (see chapter 7.1).