User's Manual

Functions
4.9 Specify parameters for target device
CamTool
4-34 Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0
Field/button Explanation/instructions
Slave axis
Basic scaling Enter the basic scaling of the slave axis here. The center of the scaling is
always the coordinate origin.
Note:
Do not use any scaling values which are greater than 5. Greater values
cause a roughness in the curve characteristic.
Scalings You can specify the scalings of two ranges of the slave axis here. The
center of the scaling is the start point of the scaling range.
Note:
If you specify two ranges, the ranges cannot overlap.
(Range1) Under From and To, enter the range that you want to scale. Under
Factor, enter the scaling factor.
Note:
Do not use any scaling values which are greater than 5. Greater values
cause a roughness in the curve characteristic.
(Range2) Under From and To, enter the range that you want to scale. Under
Factor, enter the scaling factor.
Note:
Do not use any scaling values which are greater than 5. Greater values
cause a roughness in the curve characteristic.
Offset You can enter a factor for the offset of the slave axis here. If you have
specified a scaling, the offset applies to the scaled curve. If you have not
specified a scaling, the offset applies to the unscaled curve.