User's Manual

Configuring
3.5 Customize the display of the cam
CamTool
3-18 Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0
3. Either the window Master Properties (for the master axis) or the window S Diagram
Properties (Slave) (for the slave axis) is displayed.
For the master axis, change the representation parameters in the window Master Properties.
Figure 3-11 Master Properties window
For the slave axis, change the representation parameters in the window S Diagram (Slave)
Properties.
Figure 3-12 Slave Properties window
Table 3-2 Parameters in the Master Properties or S Diagram (Slave) Properties
Field/button Explanation/instructions
Master Range
(Master Properties)
You specify the master range (definition range) of the curve
via start and end points. Cam segments must lie within this
master range (see also Master range under Target device
properties in the Coordinates tab).
Start Enter the start point of the curve, or the start of the master
range of the curve here.
End Enter the end point of the curve, or the end of the master
range of the curve here.