User's Manual

Configuring

3.3 Editing a Cam with CamTool

CamTool

3-14 Configuration Manual, 12.2004, 6AU1900-1AB32-0BA0

2. Click a diagram to show the Cam menu.

6HJPHQWERXQGDU\

)L[HGSRLQW

,QWHUSRODWLRQFXUYHWUDQVLWLRQ

6GLDJUDPGLVWDQFHGLDJUDP

9GLDJUDPYHORFLW\GLDJUDP

$GLDJUDPDFFHOHUDWLRQGLDJUDP

Figure 3-9 Cam segment replaced by SIMOTION CamTool with fixed point and transition

(interpolation polynomial)

3. Click the menu Cam > Upload cam. The cam is uploaded from the SIMOTION device.

4. After the upload, you can change back to OFFLINE status. Click the menu

Project > Disconnect from target system.

Notice

When you upload a cam from the SIMOTION device and have previously changed the

displayed cam, a window appears. You can accept the changed cam into the project via

the window. The cam is then uploaded from the SIMOTION device.