User guide

Controller, Access Points and Convergence Software configuration
A31003-W1010-A100-1-7619, July 2005
36 HiPath Wireless Controller, Access Points and Convergence Software V3.0: User Guide
HWC_SoftwareConfig.fm
Setting up static routes
Setting up a static route on the HiPath Wireless Controller
1. Click on the HiPath Wireless Controller tab. In the HiPath Wireless Controller
Configuration screen, click on the Routing Protocols option.
2. Click the Static Routes tab. The Static Routes screen appears.
3. To add a new route, click in the Destination Address field and key in the destination IP
address of a packet.
[The destination network IP address that this static route applies to. Packets with this
destination address will be sent to the Destination below.]
To define a default static route for any unknown address not in the routing table, key in
0.0.0.0.
4. Key in the Subnet Mask. For the IP address, the appropriate subnet mask to separate the
network portion from the host portion of the address (typically 255.255.255.0).
For the default static route for any unknown address, key in 0.0.0.0.
5. In the Gateway field, key in the IP address of the gateway (the IP address of the specific
router port or gateway on the same subnet as the HiPath Wireless Controller to which to
route these packets; that is, the IP address of the next hop between the HiPath Wireless
Controller and the packet’s ultimate destination).
6. Click on the Add button. The new route appears in the list, numbered sequentially.