Installation Instructions

Document No. 129-910
Installation Instructions
May 28, 2015
Page 2 of 3
Install new switch plate and route wiring
harness
1. Install new switch plate using the four hex
nuts removed in Step 1.
2. Use a 7 mm nut driver to securely tighten
hex nuts.
Figure 5. Switch Plate Installed.
3. Route wiring harness to the diagnostics
board using adhesive mounts and wire ties
(included). Trim wire ties as necessary after
cinching.
Figure 6. Routed Wiring Harness.
Terminate harness and complete
installation
1. Terminate the wiring harness lugs at the
override jumper.
NOTE:
You may terminate either lug on either post.
Figure 7. Override Jumper Location.
Figure 8. Terminated Switch Harness.
2. Close bypass door.
Figure 9. Completed Installation.
The installation is now complete.