Installation Instructions

ManualsBrandsSiemens ManualsVariable Speed DriveElectronic Bypass OVerridwe Switch Kit Installatin Instructions

Table Of Contents

Document No. 129-910

May 28, 2015

Electronic Bypass Override Switch Kit

Item Number 129-910, Rev. AA

Page 1 of 3

Product Description

This kit contains the parts needed to install an

Electronic Bypass Override Switch on an existing

BTE Bypass unit.

Contents

Figure 1. Contents.

• Switch plate with override switch

• Wire harness

• Wire ties

• Adhesive mounts

Product Number

BTE-SW-KIT

Warning/Caution Notations

WARNING:

Personal injury/loss of life

may occur if you do not

follow the procedures as

specified.

CAUTION:

Equipment damage, or loss

of data may occur if you do

not follow the procedures as

specified.

Required Tools

• 7 mm nut driver/socket

• Small wire cutters

Expected Installation Time

10 minutes

Prerequisites

WARNING:

Disconnect and lock-out power, and wait at

least five minutes prior to installing.

Installation

Remove existing coverplate

1. Open bypass door.

2. Remove and retain four M4 hex nuts from

the existing coverplate.

Figure 2. Coverplate (Exterior View).

3. Remove coverplate and retain for future

reinstallation (if desired).

Figure 3. Coverplate Screws (Interior View).

Figure 4. Coverplate Removed.

Summary of content (3 pages)

PAGE 1
Installation Instructions Document No. 129-910 May 28, 2015 Electronic Bypass Override Switch Kit Product Description This kit contains the parts needed to install an Electronic Bypass Override Switch on an existing BTE Bypass unit. Contents Prerequisites WARNING: Disconnect and lock-out power, and wait at least five minutes prior to installing. Installation Remove existing coverplate 1. Open bypass door. 2. Remove and retain four M4 hex nuts from the existing coverplate. Figure 1. Contents.
PAGE 2
Document No. 129-910 Installation Instructions May 28, 2015 Install new switch plate and route wiring harness 1. Install new switch plate using the four hex nuts removed in Step 1. 2. Use a 7 mm nut driver to securely tighten hex nuts. Terminate harness and complete installation 1. Terminate the wiring harness lugs at the override jumper. NOTE: You may terminate either lug on either post. Figure 5. Switch Plate Installed. 3.
PAGE 3
Document No. 129-910 Installation Instructions May 28, 2015 Switch Operation There are two modes of operation for the BT300 Electronic Bypass when using the Override Switch Kit (BTE-SW-KIT): 1. STANDARD Mode – This is the default operation mode. The switch must be in this position to enable the Drive to control the attached motor. The switch will control the motor in Drive (Auto or Hand), Off, and Bypass as Normal with the electronic bypass function of the Drive.