Installation Instructions

Installation Instructions
Document No. DPD01589
May 8, 2014
Page 1 of 12
BT300 VFD Bypass Option
EMC Filter Package
Product Description
The EMC Filter cleans the three-phase
power input to a BT300 VFD Bypass
Option.
Expected Installation Time
• Frames 4 & 5: 15 minutes
• Frames 6 & 7: 30 minutes
Warning/Caution Notations
• This equipment generates, uses,
and radiates radio frequency
energy. If not installed and used
in accordance with the
instructions manual, may cause
interference to radio
communications.
• Operation of this equipment in a
residential area may cause
interference. At their own
expense, users will be required to
take whatever measures to
correct the interference.
• Main short circuit protection and
disconnect by others. Branch
circuit protection to be provided
by installer per UL508A, if not
provided with drive.
Note: Bypass with EMC Filter
package has been tested and found
to comply with the limits for a Class
A digital devices, pursuant to Part 15
of the FCC rules. These limits are
designed to provide reasonable
protection against such interference
when operated in a commercial
environment.
WARNING:
Serious injury, death, or
sever
e equipment damage
could occur if a procedure
or instruction is not
followed as specified.
Le non respect d'une
procédure ou instruction
peut provoquer des
blessures graves voir
mortelles ou endommager
l'équipement
NOTICE
!
Equipment damage or
unwanted operation may
occur if a procedure or
instruction is not followed
as specified.
Le non respect d'une
procédure ou instruction
peut endommager
l'équipement ou
entraîner un
fonctionnement
intempestif.
Prerequisites
• Check for shipping damage. In the event
of damage, contact the transport
company.
• Bypass Option must be previously
installed.