Installation Instructions

Document No. DPD01160D
Installation Instructions
December 4, 2019
Page 2 of 4
Figure 3.
4. To attach the cables. fold the cable shield
backwards onto the cable and attach the
cable with a cable clamp on the shield.
NOTE:
See Siemens BT300 HVAC Drive
Installation Instructions (DPD01148) for
detailed cable installation instructions.
Figure 4.
5. Install supply cable S and connect it to the
main switch (see Figure 5).
NOTES:
1. If possible, protect the cables closest to
the main switch with an insulation tube.
2. See Siemens BT300 HVAC Drive
Installation Instructions (DPD01148) for
detailed cable installation instructions.
Figure 5.
Figure 6. Motor and Supply Cable Installation
as Seen from Above.
6. Attach the main switch screws.
Figure 7.
7. Tighten the supply cable screws according
to the tightening torques in Table 2. Check
the tightening of the factory-installed cable
connection screws on the right side of the
main switch.
Figure 8.
Connecting the data cable
Do one of the following:
• For FS4: Connect Data Cable D under the
main switch, and attach it.
• For FS5 through FS7: Connect the data
cable to the terminal around the main
switch.