Operating Instructions

Siemens Industry, Inc. • 44 Siemens Application
24-hour support [phone] (Dial 2)
3.5.7.3 Digital outputs, slot B (Basic)
Table 31: Digital output settings on standard I/O board.
Code Parameter Min Max Unit Default ID Description
P3.5.3.2.1 Basic R01 function 0 35 2 11001
Function selection for Basic
R01:
0 = None
1 = Ready
2 = Run
3 = General fault
4 = General fault inverted
5 = General alarm
6 = Reversed
7 = At speed
8 = Motor regulator active
9 = Preset speed active
10 = Keypad control active
11 = I/O B control activated
12 = Limit supervision 1
13 = Limit supervision 2
14 = Start signal active
15 = Reserved
16 = Fire Mode activation
17 = RTC time chnl 1
control
18 = RTC time chnl 2
control
19 = RTC time chnl 3
control
20 = FB ControlWord B13
21 = FB ControlWord B14
22 = FB ControlWord B15
23 = PID1 in Sleep mode
24 = Reserved
25 = PID1 supervision limits
26 = PID2 supervision limits
27 = Motor 1 control
28 = Motor 2 control
29 = Motor 3 control
30 = Motor 4 control
31 = Reserved (Always
open)
32 = Reserved (Always
open)
33 = Reserved (Always
open)
34 = Maintenance alarm
35 = Maintenance fault
P3.5.3.2.2 Basic R01 ON delay 0.00 320.00 s 0.00 11002 ON delay for relay
P3.5.3.2.3 Basic R01 OFF delay 0.00 320.00 s 0.00 11003 OFF delay for relay
P3.5.3.2.4 Basic R02 function 0 35 3 11004 See P3.5.3.2.1
P3.5.3.2.5 Basic R02 ON delay 0.00 320.00 s 0.00 11005 See P3.5.3.2.2.
P3.5.3.2.6 Basic R02 OFF delay 0.00 320.00 s 0.00 11006 See P3.5.3.2.3.
P3.5.3.2.7 Basic R03 function 0 35 1 11007
See P3.5.3.2.1.
Not visible if only 2 output
relays are installed