Operating Instructions
Table Of Contents
- 1. Siemens BT300 - Startup
- 2. Keypad of the drive
- 3. Siemens Application
- 3.1 Specific functions of the Siemens application
- 3.2 Example of control connections
- 3.3 Application - Quick setup parameter group
- 3.4 Monitor group
- 3.5 Application parameter lists
- 3.5.1 Parameter programming
- 3.5.2 Column explanations
- 3.5.3 Group 3.1: Motor settings
- 3.5.4 Group 3.2: Start/Stop setup
- 3.5.5 Group 3.3: Control reference settings
- 3.5.6 Group 3.4: Ramp & Brakes Setup
- 3.5.7 Group 3.5: I/O Configuration
- 3.5.8 Group 3.6: Fieldbus Data Mapping
- 3.5.9 Group 3.7: Prohibited Frequencies
- 3.5.10 Group 3.8: Limit supervisions
- 3.5.11 Group 3.9: Protections
- 3.5.12 Group 3.10: Automatic reset
- 3.5.13 Group 3.11: Timer functions
- 3.5.14 Group 3.12: PID-controller 1
- 3.5.15 Group 3.13: PID-controller 2
- 3.5.16 Group 3.14: Multi-pump
- 3.5.17 Group 3.16: Fire mode
- 3.5.18 Group 3.17: Application settings
- 3.6 HVAC Application - Additional parameter information
- 3.7 Application - Fault tracing
Siemens Industry, Inc. • 16 Keypad of the drive
24-hour support +1-800-877-7545 (Dial 2)
2.2.5 I/O and hardware
Various options-related settings are located in this menu.
2.2.5.1 Basic I/O
Monitor here the status of inputs and outputs.
Table 4: I/O and Hardware menu, Basic I/O parameters.
Code Parameter Min Max Unit Default ID Description
V5.1.1 Digital input 1 0 1 Status of digital input signal
V5.1.2 Digital input 2 0 1 Status of digital input signal
V5.1.3 Digital input 3 0 1 Status of digital input signal
V5.1.4 Digital input 4 0 1 Status of digital input signal
V5.1.5 Digital input 5 0 1 Status of digital input signal
V5.1.6 Digital input 6 0 1 Status of digital input signal
V5.1.7
Analog input 1
mode
13
Shows the selected (with
jumper) mode for analog input
signal
1 = 0...20 mA
3 = 0...10 V
V5.1.8 Analog input 1 0 100 % Status of analog input signal
V5.1.9
Analog input 2
mode
13
Shows the selected (with
jumper) mode for analog input
signal
1 = 0...20 mA
3 = 0...10 V
V5.1.10 Analog input 2 0 100 % Status of analog input signal
V5.1.11
Analog output 1
mode
13
Shows the selected (with
jumper) mode for analog out-
put signal
1 = 0...20 mA
3 = 0...10 V
V5.1.12 Analog output 1 0 100 % Status of analog output signal