Operating Instructions

Siemens Industry, Inc. • 30 Siemens Application
24-hour support [phone] (Dial 2)
3.5 Application parameter lists
Find the parameter menu and the parameter groups as guided below.
The application contains the following parameter groups:
Table 22. Parameter groups.
Menu and Parameter group Description
Group 3.1: Motor settings Basic and advanced motor settings.
Group 3.2: Start/Stop setup Start and stop functions.
Group 3.3: Control reference settings Frequency reference setup.
Group 3.4: Ramp & Brakes Setup Acceleration/Deceleration setup.
Group 3.5: I/O Configuration I/O programming
Group 3.6: Fieldbus Data Mapping Fieldbus data out parameters.
Group 3.7: Prohibited Frequencies Prohibit frequencies programming.
Group 3.8: Limit supervisions Programmable limit controllers.
Group 3.9: Protections Protections configuration
Group 3.10: Automatic reset Auto reset after fault configuration.
Group 3.11: Timer functions
Configuration of 3 timers based on Real Time
Clock.
Group 3.12: PID-controller 1
Parameters for PID Controller 1. Motor control or
external usage.
Group 3.13: PID-controller 2 Parameters for PID Controller 2. External usage.
Group 3.14: Multi-pump Parameters for multi-pump usage.
Group 3.16: Fire mode Parameters for Fire Mode.

(17)

(6)

ID: M3
STOP READY Keypad
(13)

STOP READY Keypad




(2)
(7)
(18)
ID: M3.1
BT11091
Main Menu
Quick Setup
Monitor
Parameters
Motor Settings
Start/Stop Setup
References
Parameters