Operating Instructions
Table Of Contents
- 1. Siemens BT300 - Startup
- 2. Keypad of the drive
- 3. Siemens Application
- 3.1 Specific functions of the Siemens application
- 3.2 Example of control connections
- 3.3 Application - Quick setup parameter group
- 3.4 Monitor group
- 3.5 Application parameter lists
- 3.5.1 Parameter programming
- 3.5.2 Column explanations
- 3.5.3 Group 3.1: Motor settings
- 3.5.4 Group 3.2: Start/Stop setup
- 3.5.5 Group 3.3: Control reference settings
- 3.5.6 Group 3.4: Ramp & Brakes Setup
- 3.5.7 Group 3.5: I/O Configuration
- 3.5.8 Group 3.6: Fieldbus Data Mapping
- 3.5.9 Group 3.7: Prohibited Frequencies
- 3.5.10 Group 3.8: Limit supervisions
- 3.5.11 Group 3.9: Protections
- 3.5.12 Group 3.10: Automatic reset
- 3.5.13 Group 3.11: Timer functions
- 3.5.14 Group 3.12: PID-controller 1
- 3.5.15 Group 3.13: PID-controller 2
- 3.5.16 Group 3.14: Multi-pump
- 3.5.17 Group 3.16: Fire mode
- 3.5.18 Group 3.17: Application settings
- 3.6 HVAC Application - Additional parameter information
- 3.7 Application - Fault tracing
Keypad of the drive Siemens Industry, Inc. • 19
24-hour support +1-800-877-7545 (Dial 2)
2
2.2.6 User settings
2.2.6.1 Parameter backup
Table 8: User settings menu, General settings.
Code Parameter Min Max Unit Default ID Description
P6.1 Language selections Varies Varies Varies 802
Depends on language
package.
P6.2 Application selection 801
M6.5 Parameter backup See Chapter 2.2.6.1 below.
P6.7 Drive name
Give name of drive if
needed.
Table 9: User settings menu, Parameter backup parameters.
Code Parameter Min Max Unit Default ID Description
Save to set
P6.5.1
Restore factory
defaults
831
Restores default parame-
ter values and initiates the
Startup Wizard
P6.5.2 Save to keypad 0 1 0
Save parameter values to
keypad to e.g. copy them
to another drive.
0 = No
1 = Yes
P6.5.3
Restore from
keypad
Load parameter values
from keypad to the drive.