Operating Instructions

Siemens Industry, Inc. • 14 Keypad of the drive
24-hour support [phone] (Dial 2)
2.2.3 Parameters
Through this sub-menu, you can reach the application parameter groups and parameters. You can find
more information on parameters in Chapter 3.
2.2.4 Diagnostics
Under this menu, you can find Active faults, Reset faults, Fault history, Counters and Software info
.
2.2.4.1 Active faults
2.2.4.2 Reset faults
2.2.4.3 Fault history
Menu Function Note
Active faults When a fault/faults display(s), the dis-
play with the name of the fault starts to
blink. Press OK to return to the Diag-
nostics menu. The Active faults sub-
menu shows the number of faults. Se-
lect the fault and push OK to see the
fault-time data.
The fault remains active until it is cleared
with the Reset button (push for 2 s) or
with a reset signal from the I/O terminal or
fieldbus or by choosing Reset faults (see
below).
The memory of active faults can store the
maximum of 10 faults in the order of
appearance.
Menu Function Note
Reset faults In this menu you can reset faults. For
closer instructions, see Chapter 3.7.1.
CAUTION! Remove external Cont-
rol signal before resetting the fault to pre-
vent unintentional restart of the drive.
Menu Function Note
Fault history
40 latest faults are stored in the Fault
history.
Entering the Fault history and clicking OK
on the selected fault shows the fault time
data (details).
Application info Application ID Information (Application ID, Version and
Firmware interface) about applications
loaded
into the variable frequency drive.
Firmware interface
Hardware info Unit power Unit power in kW
Unit voltage Nominal voltage of the unit
Statistics Output current profile
Output frequency profile
Unit temperature profile