Operating Instructions
Table Of Contents
- 1. Siemens BT300 - Startup
- 2. Keypad of the drive
- 3. Siemens Application
- 3.1 Specific functions of the Siemens application
- 3.2 Example of control connections
- 3.3 Application - Quick setup parameter group
- 3.4 Monitor group
- 3.5 Application parameter lists
- 3.5.1 Parameter programming
- 3.5.2 Column explanations
- 3.5.3 Group 3.1: Motor settings
- 3.5.4 Group 3.2: Start/Stop setup
- 3.5.5 Group 3.3: Control reference settings
- 3.5.6 Group 3.4: Ramp & Brakes Setup
- 3.5.7 Group 3.5: I/O Configuration
- 3.5.8 Group 3.6: Fieldbus Data Mapping
- 3.5.9 Group 3.7: Prohibited Frequencies
- 3.5.10 Group 3.8: Limit supervisions
- 3.5.11 Group 3.9: Protections
- 3.5.12 Group 3.10: Automatic reset
- 3.5.13 Group 3.11: Timer functions
- 3.5.14 Group 3.12: PID-controller 1
- 3.5.15 Group 3.13: PID-controller 2
- 3.5.16 Group 3.14: Multi-pump
- 3.5.17 Group 3.16: Fire mode
- 3.5.18 Group 3.17: Application settings
- 3.6 HVAC Application - Additional parameter information
- 3.7 Application - Fault tracing
Siemens Application Siemens Industry, Inc. • 51
24-hour support +1-800-877-7545 (Dial 2)
3
P3.9.19
Response to Fieldbus
communication fault
0 4 3 733 See P3.9.1
P3.9.20
Slot communication
fault
0 3 2 734 See P3.9.2
P3.9.21 Thermistor fault 0 3 0 732
See P3.9.2
It is recommended to set
this value to 2 if an option
card is installed which has
a thermistor present.
P3.9.22
Response to PID1
supervision fault
0 3 2 749 See P3.9.2
P3.9.23
Response to PID2
supervision fault
0 3 2 757 See P3.9.2
P3.9.26 TempFault Signal 0 6
Not
Used
739
Selection for which signals to
use for alarm and fault trig-
gering.
P3.9.27 TempAlarm Limit -30.0 200.0 130.0 741
Temperature for trigging an
alarm.
P3.9.28 TempAlarm Limit -30.0 200.0 155.0 742
Temperature for trigging a
fault.
P3.9.29 TempFault Response 0 3 Fault 740
Fault response for Tempera-
ture Fault.
0 = No response
1 = Alarm
2 = Fault (Stop according to
stop mode)
3 = Fault (Stop by coasting)
Table 39: Protections settings.
Code Parameter Min Max Unit Default ID Description