Operating Instructions

Demonstration Panel Overview
3
Operation Overview
11
Siemens Industry, Inc. 125-1007 Rev.BA
2014-08-14
Operation Overview
The Demonstration Panel is shipped with a foam insert located above the BT300 Drive.
This must be removed before the unit is powered up. It must also be inserted before
the unit is closed up for shipping.
The Demonstration Panel is powered using the provided power cord that is connected
to the rear of the demo unit and to a standard 110/115 Vac outlet.
Figure 5: Demonstration Panel Power Cord.
The Demonstration Panel can be set into two different operating modes, one is for
VFD-only demonstrations, and the other is for VFD with Electronic Bypass
demonstrations. The mode selection switch is located below the drive on the right hand
side of the Demonstration Panel. This mode switch will put the contactors into the
proper position when the bypass option is not used.
Figure 6: Demonstration Panel Mode Switch.