Operating Instructions
Table Of Contents
- 1. Siemens BT300 - Startup
- 2. Keypad of the drive
- 3. Siemens Application
- 3.1 Specific functions of the Siemens application
- 3.2 Example of control connections
- 3.3 Application - Quick setup parameter group
- 3.4 Monitor group
- 3.5 Application parameter lists
- 3.5.1 Parameter programming
- 3.5.2 Column explanations
- 3.5.3 Group 3.1: Motor settings
- 3.5.4 Group 3.2: Start/Stop setup
- 3.5.5 Group 3.3: Control reference settings
- 3.5.6 Group 3.4: Ramp & Brakes Setup
- 3.5.7 Group 3.5: I/O Configuration
- 3.5.8 Group 3.6: Fieldbus Data Mapping
- 3.5.9 Group 3.7: Prohibited Frequencies
- 3.5.10 Group 3.8: Limit supervisions
- 3.5.11 Group 3.9: Protections
- 3.5.12 Group 3.10: Automatic reset
- 3.5.13 Group 3.11: Timer functions
- 3.5.14 Group 3.12: PID-controller 1
- 3.5.15 Group 3.13: PID-controller 2
- 3.5.16 Group 3.14: Multi-pump
- 3.5.17 Group 3.16: Fire mode
- 3.5.18 Group 3.17: Application settings
- 3.6 HVAC Application - Additional parameter information
- 3.7 Application - Fault tracing
Siemens Application Siemens Industry, Inc. • 27
24-hour support +1-800-877-7545 (Dial 2)
3
3.4.4 PID1 controller monitoring
3.4.5 PID2 controller monitoring
3.4.6 Multi-pump monitoring
Table 17: PID1-controller value monitoring.
Code Monitoring value Unit ID Description
V2.4.1 PID1 setpoint Varies 20 Process units selected with parameter
V2.4.2 PID1 feedback Varies 21 Process units selected with parameter
V2.4.3 PID1 error value Varies 22 Process units selected with parameter
V2.4.4 PID1 output % 23 Output to motor control or external control (AO)
V2.4.5 PID1 status 24
0 = Stopped
1 = Running
3 = Sleep mode
4 = In dead band (see page 58)
Table 18: PID2-controller value monitoring.
Code Monitoring value Unit ID Description
V2.5.1 PID2 setpoint Varies 83 Process units selected with parameter
V2.5.2 PID2 feedback Varies 84 Process units selected with parameter
V2.5.3 PID2 error value Varies 85 Process units selected with parameter
V2.5.4 PID2 output % 86 Output to external control (AO)
V2.5.5 PID2 status 87
0 = Stopped
1 = Running
2 = In dead band (see page 58)
Table 19: Multi-pump monitoring.
Code Monitoring value Unit ID Description
V2.6.1 Motors running 30
The number of motors running when Multi-Pump
function is used.
V2.6.2 Auto-change 1114 Informs the user if auto-change is requested.