Operating Instructions
Table Of Contents
- 1. Siemens BT300 - Startup
- 2. Keypad of the drive
- 3. Siemens Application
- 3.1 Specific functions of the Siemens application
- 3.2 Example of control connections
- 3.3 Application - Quick setup parameter group
- 3.4 Monitor group
- 3.5 Application parameter lists
- 3.5.1 Parameter programming
- 3.5.2 Column explanations
- 3.5.3 Group 3.1: Motor settings
- 3.5.4 Group 3.2: Start/Stop setup
- 3.5.5 Group 3.3: Control reference settings
- 3.5.6 Group 3.4: Ramp & Brakes Setup
- 3.5.7 Group 3.5: I/O Configuration
- 3.5.8 Group 3.6: Fieldbus Data Mapping
- 3.5.9 Group 3.7: Prohibited Frequencies
- 3.5.10 Group 3.8: Limit supervisions
- 3.5.11 Group 3.9: Protections
- 3.5.12 Group 3.10: Automatic reset
- 3.5.13 Group 3.11: Timer functions
- 3.5.14 Group 3.12: PID-controller 1
- 3.5.15 Group 3.13: PID-controller 2
- 3.5.16 Group 3.14: Multi-pump
- 3.5.17 Group 3.16: Fire mode
- 3.5.18 Group 3.17: Application settings
- 3.6 HVAC Application - Additional parameter information
- 3.7 Application - Fault tracing
Keypad of the drive Siemens Industry, Inc. • 15
24-hour support +1-800-877-7545 (Dial 2)
2
2.2.4.4 Total counters
2.2.4.5 Trip counters
2.2.4.6 Software info
Table 1: Diagnostics menu, Total counters parameters.
Code Parameter Min Max Unit Default ID Description
V4.4.1 Energy counter Varies 2291
Amount of energy taken
from supply network. No
reset.
V4.4.3 Operating time y d hh:mm 2298 Control unit operating time
V4.4.7 Run time y d hh:mm 2293 Motor running time
V4.4.11 Power on time y d hh:mm 2294
Amount of time the power
unit has been powered so
far. No reset.
V4.4.15
Start command
counter
2295
The number of times the
power unit has been
started.
Table 2: Diagnostics menu, Trip counters parameters.
Code Parameter Min Max Unit Default ID Description
P4.5.1 Energy trip counter Varies 2296
Resettable energy
counter.
NOTE: The highest
energy unit shown on the
standard keypad is MW.
Should the counted
energy exceed 999.9 MW,
no unit is shown on the
keypad.
P4.5.3 Operating time y d hh:mm 2299 Resettable. See P4.5.1.
P4.5.4 Operating time y
Operating time in total
years
P4.5.5 Operating time d
Operating time in total
days
P4.5.6 Operating time hh:mm:ss
Operating time in hours,
minutes and seconds
Table 3: Diagnostics menu, Software info parameters.
Code Parameter Min Max Unit Default ID Description
V4.6.1 Software package
V4.6.4 System load 0 100 % 2300 Load on control unit CPU.
V4.6.5 Application name Name of application
V4.6.6 Application ID
V4.6.7 Application version