User`s guide
A-14 Oracle Database Installation and Administration Guide
Cause: In the start parameters for the Oracle Database there is a syntax error.
Action: Refer to Chapter 8, "openUTM Product Set"and correct the start
parameters.
ORA-05155: Internal Error: malloc in dbstpa
Cause: This error message indicates a system error. One of the possible reasons for
this issue is that the system is out of memory.
Action: Contact the Oracle Support Services Representative.
ORA-05156: Internal Error: realloc in dbstpa
Cause: This error message indicates a system error. One of the possible reasons for
this issue is that the system does not have sufficient memory.
Action: Contact the Oracle Support Services Representative.
ORA-05157: Internal Error: malloc in up_recovery
Cause: This error message indicates a system error. One of the possible reasons for
this issue is that the system does not have sufficient memory.
Action: Contact the Oracle Support Services Representative.
ORA-05158: IUTMDB-Function not supported
Cause: openUTM system error.
Action: Contact the Oracle Support Services Representative.
ORA-05159: TA for User(s) z rolled back; Reason: Recovery
Cause: In a openUTM warmstart one or more interrupted transactions have been
rolled back.
Action: None.
ORA-05161: TCP/IP can't perform asynchronous test on break socket.
Cause: Select on break socket failed.
Action: Contact the System Administrator about TCP/IP networking problems. If
the error persists, contact the Oracle Support Services Representative.
ORA-05165: function not supported
Cause: Either Oracle Database 11g Release 2 Server or BS2000/OSD does not
support this function.
Action: None.
ORA-05167: Defect in data buffer
Cause: This is an internal error and should not normally occur.
Action: Contact the Oracle Support Services Representative.
ORA-05170: SID not defined (ORAENV file missing?)
Cause: The system identifier, data base name, is not defined when needed during
Oracle Database program initialization. A missing
ORAENV
file or a missing
ORASID
entry in that file could cause this error.
Action: Ensure that the
ORAENV
file definition is correct and re-run the program.
ORA-05173: bad kernel size
Cause: An invalid value for the
KNL_SIZE
parameter has been specified in the
ORAENV
file.