User Manual

ManualsBrandsSiemens ManualsBuilding automationBPS communication Function sheet

Siemens Building Technologies CM2N8885E / 10.1999

Landis & Staefa Division 1/4

885

VISONIK

BPS operation and display

Function sheet

The VISONIK BPS local operation and display offers all important operating

functions for the automation level such as:

•

Indicating operating and error statuses

•

Changing setpoints, timeswitch entries, etc.

•

Printing alarms and reports

VISONIK BPS local operation is used mainly on autonomous process stations but

provides the same functionality as if connected to a Building Level Network (BLN). The

following are operated primarily:

– Building services plants connected via the P-bus and I/O modules

– Room control systems integrated via the Floor Level Network (FLN) such as TEC

TEC

FLN

BTA

BLN

RWI

BPS

P-bus

8885Z01E

POP Cards

PC operation

I/O modules

There are two variants for local operation and display:

Variant Interpretation

POP Cards Operating cards labelled in clear text are inserted in the swing-out

compartment at the front of the VISONIK BPS. There are:

–

plant-specific project cards created for the operator

–

general-use service cards for system technicians

PC operation The L&S-Software „New VISOTOOL Editor” is loaded on a PC which

can be connected to the tool interface via an adapter on the BPS

front. This allows for the following:

–

menu-guided operation by the operator

–

COLBAS operation by the system technician

Use

Variants in operation

Summary of content (4 pages)

PAGE 1
8 885 VISONIK® BPS operation and display Function sheet The VISONIK BPS local operation and display offers all important operating functions for the automation level such as: • Indicating operating and error statuses • Changing setpoints, timeswitch entries, etc. • Printing alarms and reports Use VISONIK BPS local operation is used mainly on autonomous process stations but provides the same functionality as if connected to a Building Level Network (BLN).
PAGE 2
POP Cards The following example shows how an operator uses the plant-specific POP Cards. The same operating principles also apply to service cards. Example If so specified in the order, 2 to 3 project cards are created for each plant or group as shown below for a heating group: Timer tR1 tR2 tAU Heating group tVL Plant control Control loop 8885Z02E „Plant control“ card For operation, the card is inserted in the compartment at the front of the unit.
PAGE 3
Menu-guided operation Menu-guided operation in the VISONIK BPS uses dialog procedures. A selection is always displayed on-screen. The selection contains other menus as well as changeable states and values. The following screenshots provide an overview of both functionality and operation. The main menu After establishing connection and entering the password for KEY1 or KEY2, the BPS opens the main menu.
PAGE 4
Operation with COLBAS Operation with COLBAS is intended primarily for system technicians. COLBAS stands for Control-Oriented Language for Building Automation Systems. This language was used for programming the VISONIK BPS control of the associated plants. Additionally, further commands are available for operation. The following are examples of such commands. Requirement For operation using COLBAS commands, a PC with the „New VISOTOOL Editor“ must be connected to the VISONIK BPS tool interface.