User Manual

Siemens Building Technologies CM2N8878en / 01.05.02
Building Automation 3/4
The BATIGYR controllers integrated as data points can be operated via:
• POP cards.
• Insight station on the DCS.
• VISOTOOL Editor.
DCS / Insight
VISOTOOL
Editor
BatiBUS
12
11 12
13
MS
MMM
1
2
3
4
5
POP cards
Group 1
Group 2
8878Z03en
There is a POP card set for local operation at the BPS. This set consists of 5 cards with
the following operating options:
Card Operating option
1
Read
controller
After selecting the desired controller, read all controller values. See page
2, @PLT.
2
Operate
controller
After selecting the desired controller, change the values for:
– Operating mode (Comfort, Economy, Standby).
– Setpoints for heating and cooling during Comfort.
– Changeover command.
3
Operate
group
After selecting the desired group, read all group values. See page 2,
point type @AI.
If VCF is set from Auto to 1, 2, or 3, the hot and cold water valves can be
closed manually for service.
4
Operate all
controllers
For commissioning and service:
Change the operating mode, setpoints, limit values, and rules for heating
and cooling during Comfort and Economy.
Each parameter change is transmitted to all controllers.
5
Energy
handling
Selected controller:
The energy values of the controller can be read.
Selected group:
The energy values of the group can be read and changed.
The same concept as shown above for the POP cards can be implemented for
controllers and groups in Insight.
The VISOTOOL Editor on a PC allows for operating all previously described controller
or group parameters. Additional, special tasks for the BPS are available for
configuration and commissioning purposes:
– Define the controllers, groups, and master/slave relations (TSK 18).
– Automatically generate the data points and check the controllers (TSK 19).
– Print the configuration (TSK 42).
– Status report: Values or all configured BATIGYR controllers and groups (TSK 41).
Operation
Options
POP cards
Insight station on the
DCS
VISOTOOL Editor