User Manual

ManualsBrandsSiemens ManualsBuilding automationBPS communication Function sheet

Siemens Building Technologies CM2N8888E / 10.1999

Landis & Staefa Division 1/4

888

VISONIK

BPS reports

Function sheet

The VISONIK BPS can output various reports: From individual point reports to

system reports containing comprehensive information, event-dependent or on

user request. This function sheet provides an overview of the most important

reports and the corresponding information.

Reports of the VISONIK BPS provide information on the respectively assigned building

services plants in the form of on-screen clear text or printouts:

8888Z01

BPS

The following table contains an overview of the reports that can be generated:

Name The report lists ...

System report all configured information points of the associated BPS, or

controlled by selectors: selected point types, address ranges,

and groups.

Alarm report the information points that have assumed a fault or warning

state (selectors as above)

Error report the information points that have assumed an error state

(selectors as above)

PLT report the existing plants and their operating states, displayed in short

form via software point PLT

Individual point report the state of a specific point

Optimisation report a zone point folder (plants with Optimum Start Stop Program)

including a display of the most important values

Room management

report

all important information on groups, rooms, and controllers of

an integrated room control system

Use

Overview of reports

Summary of content (4 pages)

PAGE 1
8 888 VISONIK® BPS reports Function sheet The VISONIK BPS can output various reports: From individual point reports to system reports containing comprehensive information, event-dependent or on user request. This function sheet provides an overview of the most important reports and the corresponding information.
PAGE 2
Report generation and structure Report generation All previously listed reports can be generated in two ways: • on operator or program request (VDI 3814: overview reports) • spontaneously through events as soon as these are recognised by the VISONIK BPS Operators can call up the reports on the VISONIK BPS via the POP Cards or via a PC with menu-guided operation or via COLBAS commands. Structure of reports All VISONIK BPS reports have the same structure.
PAGE 3
Example: Overview report System report SYR The picture below contains an example for an overview report in the form of a system report SYR excerpt: SYR . 11:50:37 ML $d009'000 ( R E P O R T - S T A R T 1.1 2D20) 02-MAY-1996/TH Boiler North 03-MAY-1996 05:53:21 DI=1 ?FB SBR1 $d009'010 ( 5.1 2QD) Supply air fan 03-MAY-1996 07:30:05 DO=1 - MW $d009'021 ( 9.2 2R1K) DO<>FBV Supply air temperature 03-MAY-1996 11:50:37 AI=15.8 °C . STU $d009'030 ( 13.
PAGE 4
Room management report Report contents The room management report (RMR) provides information on room groups, rooms, and controllers of an individual room control system integrated in the VISONIK BPS such as: • TEC Terminal Equipment Controller (FLN bus) • MONOGYR room controller and switching units (MONOGYR bus) Example for an RMR report The following example shows a MONOGYR room management report with allocations and states of the individual room controllers and switching units: RMR 13:35:40 REPORT-ST