User's Manual

M200D AS-Interface Basic

Manual, 03/2009, A5E01668085-01

Commissioning

6.1 Prerequisites

Software requirements

Configuration software used Explanations

Configuration software for the AS-i master used See the manual for the AS-i master

Commissioning requirements

Prior activity For more information, see ...

1. Motor starter installed "Installation"

2. Address set on motor starter "Installation"

3. Supply voltage for motor starter switched on —

4. Supply voltage for load switched on (if

necessary)

See manual for motor

5. Motor starter configured (configured and

parameterized)

"Configuration / parameterization"

6. Supply voltage for AS-i master switched on —

7. AS-i master switched to RUN mode Manual for AS-i master