Specifications

Mobility and Logistics, Traffic Solutions
Sopers Lane, Poole, Dorset, BH17 7ER
Security classification Unrestricted Page 66 of 83
Version 2 Status Released
Last Editor Harry Smyth Date 09/12/2014
Document Name Configuration Control Document No. 667/CC/45950/000
Copyright © Mobility 2014. All Rights Reserved. Mobility is a division of Siemens Plc
4.11 WiMag
4.11.1 WiMag 3U Rack Kit (19”) System
WiMag is not included in the Outercase ordered from Table 4 and therefore must be
specified separately. Please refer to the parts listing. The following configuration procedure
details a basic controller WiMag installation. Full system installation details should be sought
from the WiMag Detection System General Handbook
With reference to Figure 52, the cabinet mounted equipment required as part of the WiMag
installation is mounted to the 19” WiMag Communications Rack Assembly. This unit will be
installed below the 6U Rack Unit, housing the main controller function Cards. The WiMag
Communications Rack Assembly will hold up to three standard Interface Cards, servicing 20
WiMag sensors each. Each of the standard interface cards plugs into an individual
backplane card. Sufficient space is available behind the centre section of the WiMag
Communications Rack Assembly to house the necessary 4/8 port Power Over Ethernet
(POE) Switch. A Power Supply Unit will be installed on the right hand side of the WiMag
Communications Rack Assembly. The standard WiMag Communications Rack Assembly is
supplied with one standard interface Card, and associated backplane. Additional Standard
Interface Cards should be ordered at controller configuration time. The appropriate POE unit
should also be ordered at controller configuration time.
Figure 52 - WiMag
Figure 53 - WiMag