Specifications

Mobility and Logistics, Traffic Solutions

Sopers Lane, Poole, Dorset, BH17 7ER

Security classification Unrestricted Page 41 of 83

Version 2 Status Released

Last Editor Harry Smyth Date 09/12/2014

Document Name Configuration Control Document No. 667/CC/45950/000

3.15 Stratos Outstation

The ST950 Outercase is configured with a 19” Swing Frame and a Rack Assembly. With

reference to Figure 8 the area above the Rack Assembly is set aside for Stratos Outstation.

Please also reference document 667/GA/27087/000, detailed in the related document

section of the document. A 19” Rack Kit will be fitted to the ST950 as standard and need not

be ordered separately. When a Stratos Outstation is specified it will be fitted on the right

hand side of the 19” Rack Kit, as seen from the front of the 19” Swing Frame in Figure 8.

The Master Switch Unit has one OTU Supply Kit fitted to provide power for the Stratos

Outstation. A second kit may be fitted, please refer to the parts listing for the appropriate part

number. The position of the kit is shown on diagram 667/GA/27121/000. The Stratos

Outstation has several applications; full information on the required configuration should be

sought from the Stratos Outstation Family Tree, 667/DZ/52250/ETC. With reference to

Figure 29, mains supply power for the Stratos Outstation is connected via a standard IEC

C13 mains lead. The other boards in the system are powered over the RJ45 GSPI cables.

To provide Lamp Supply monitoring on the Stratos Outstation the Lamp Supply Monitor Port

is used.

It will be noted that the 19” Rack Assembly set aside for the Stratos Outstation will be largely

empty when the Stratos Outstation is specified and completely empty when Stratos

Outstation is not specified.

Figure 29 - Power for Stratos Outstation Unit

If the internal backup battery is fitted the Stratos Outstation can be mounted in

any orientation apart from front panel facing down.

Mains

Connection

to Stratos

Outstation

Lamp

Supply

Monitor

Port