Specifications

Mobility and Logistics, Traffic Solutions

Sopers Lane, Poole, Dorset, BH17 7ER

Security classification Unrestricted Page 18 of 83

Version 2 Status Released

Last Editor Harry Smyth Date 09/12/2014

Document Name Configuration Control Document No. 667/CC/45950/000

Table 2 – Serial Link Connections

Component Input Output

CPU card Serial link derived from

CPU card

RJ45 Serial Link Output

Socket

CPU I/O Card RJ45 Serial Link Input RJ45 Serial Link Output

Termination Panel Upper

I/O Card

RJ45 Serial Link Input RJ45 Serial Link Output

Termination Panel Lower

I/O Card

RJ45 Serial Link Input RJ45 Serial Link Output

First Intelligent Detector

Backplane

RJ45 Serial Link Input RJ45 Serial Link Output

Second Intelligent Detector

Backplane

RJ45 Serial Link Input RJ45 Serial Link Output

3.3 Termination Panel

With reference to Figure 4 the mounting of both standard equipment and optional equipment

to a Controller is achieved using Termination Panels. One Termination Panel is fitted to the

1.5KVA 8ph wired version of the ST950 and two are fitted to the 3.0KVA 24ph wired version

of the ST950 controller. The Termination Panels do not need to be ordered separately as

they are contained within the Outercase, selected from Table 1. When upgrading a controller

from 1.5KVA to 3.0KVA Configuration Engineers should consult the parts listing for

additional Termination Panels. Termination panels will be positioned centrally at the rear of

the ST950 cabinet, one above the other when two panels are fitted. Certain large items have

designated positions within the controller, others are subject to optimisation. For this reason

some items may vary slightly in position, from one controller to another. Termination panels

have stencilled graphics to assist in the positioning of equipment.