Installation guide

Mobility and Logistics, Traffic Solutions

Sopers Lane, Poole, Dorset, BH17 7ER

Security classification Unrestricted Page 52 of 84

Version 1 Status Issued

Last Editor Carl Rabe Date 11-Dec-2014

Document Name Stratos Outstation General and ICM Handbook Document No. 667/HB/52250/000

5.2 Preparation

Before attending site to Install a Stratos Outstation check that you have the following pre-

requisites:

 Installation tools as described above in section 5.1.3.

 Ensure that the Outstation is the correct variant of the product.

 Ensure you have the correct licenses for the application pre-installed, or on a

Card.

 Any required Communication equipment (will be site specific).

 Communication network configuration information (Site Specific).

 OTU Supply Kit – (667/1/27121/000) (In case there are no spare fused supplies).

 Printed SAT Sheet for completion on site (667/CI/31601/002).

 Printed OTU/MOVA Set Up Form for completion on site (667/CI/31601/000).

 Handbooks etc. As described in section 1.3.

5.3 Assembly

Additional board kits should be fitted according to section 7.3.1.

The Stratos Outstation comes as standard with the following parts:

Part Description Part Number

Lamp Supply Monitor Cable 667/1/47177/000

IEC 90 degree Mains Lead 702/4/08537/000

Zip Tie for mains lead 915/4/97087/026

Fixing Kit (M6 screws, caged nuts, washers, M2.5 screws & washers 667/1/47182/000

Ethernet Cable – 1m 998/4/88323/000

Modem Power Connector 531/4/03187/172

Outstation to Controller standard serial cable 667/1/47176/100

5.4 Mounting the Stratos Outstation

The Stratos Outstation can be mounted in a number of ways depending on the

configuration required. The unit should be mounted as low as possible in the controller

cabinet to reduce operating temperatures and maximise battery life.