Specifications

Siemens Mobility, Traffic Solutions

Sopers Lane, Poole, Dorset

BH17 7ER

Version 10 Page 97 of 120 Status Issued

Last Editor harry.smyth Date 03 November 2014

Document

Name

GENERAL HANDBOOK FOR HEIMDALL

DETECTORS

Doc. No.

667/HB/31900/000

8 MAINTENANCE

Before starting any maintenance work, read the Safety Warning on page 2 of this

Handbook.

8.1 Routine Maintenance Visits

The interval between visits depends on local conditions but may consist of the following:

 check the detector securing bolt to ensure it has not worked loose,

 re-align the detector if necessary,

 ensure the configuration access door is properly retained and seated,

 clean the LED indicator lens with a soft cloth to remove dirt and grime,

 check the connection lead for any damage.

8.2 First Line Maintenance

First line maintenance will be achieved on a modular replacement basis.

Check which type of detector is fitted, make a note of its alignment to the installation

and only replace with a similar part. When carrying out detector maintenance or

replacement, wherever possible, remove the suspect item from its mounting position

and work on the ground.

Ensure the replacement detector configuration switches are set to the same positions

as the original unit.

Read the accompanying installation information to see if the detector requires any

additional special configuration using the terminal interface.

Install and re-align the detector to the previously noted position.

8.3 Second Line Maintenance

All faulty units should be returned for repair to the following address.

Siemens Mobility, Traffic Solutions

Sopers Lane

Poole

Dorset

BH17 7ER