Specifications

Siemens Mobility, Traffic Solutions

Sopers Lane, Poole, Dorset

BH17 7ER

Version 10 Page 79 of 120 Status Issued

Last Editor harry.smyth Date 03 November 2014

Document

Name

GENERAL HANDBOOK FOR HEIMDALL

DETECTORS

Doc. No.

667/HB/31900/000

6.2 Final Commissioning Procedures

Power is applied to the unit and the operation of the detector observed by looking at the

output from the indicator LED which is visible on the side door. If necessary, adjustment

can be made to the alignment by:

(1) ‘Slackening off’ the mounting nut slightly,

(2) Making the minor adjustment whilst, at the same time, observing the detector

operation by looking at the LED;

(3) Re-tighten the mounting nut.

The controller’s input status should then be checked to ensure the detector signal is

connected as required.

Ensure the detector configuration access door is replaced correctly. Refer to

appropriate detector specification (reference 5).