Specifications

Siemens Mobility, Traffic Solutions
Sopers Lane, Poole, Dorset
BH17 7ER
Version 10 Page 77 of 120 Status
Error! Unknown document
property name.
Last Editor harry.smyth Date 03 November 2014
Document Name GENERAL HANDBOOK FOR HEIMDALL
DETECTORS
Doc. No. 667/HB/31900/000
Copyright  Siemens plc 2014 All Rights Reserved
5.7.5 Side Access Configuration Dip Switch Settings
Note: Default settings are with all DIP switches set to ‘0’/ OFF.
Configuration
DIP Switch Number
1 2 3 4 5 6 7 8
Vehicle Filter
0 = Enabled
1 = Disabled
Not
Used
Detector LED
0,0 = Normal Detector O/P
0,1 = Permanently Off
1,0 = Detector O/P for 20
minutes after power applied
1,1 = Normal Detector O/P
Recalibration
Toggle switch (0-
1-0).
Detection
Length
0 = Normal
1 = Reduced
Controls the
effective range
of the detector.
DFM
0 = Default monitor time
(20 hours inactivity)
1 = ‘fault monitor time’ is set by the
Engineer’s Terminal
Remote
Configuration
0 = Disabled
1 = Enabled
Note: Some DIP switches may be marked with ON/OFF. For the purposes of definition, OFF is equal to 0 and ON is equal to 1.
Table 5-28 – Pedestrian Kerbside Detector Configuration Switch Settings
Refer to section 6 for detailed information regarding final commissioning.