Specifications

Siemens Mobility, Traffic Solutions
Sopers Lane, Poole, Dorset
BH17 7ER
Version 10 Page 66 of 120 Status
Error! Unknown document
property name.
Last Editor harry.smyth Date 03 November 2014
Document Name GENERAL HANDBOOK FOR HEIMDALL
DETECTORS
Doc. No. 667/HB/31900/000
Copyright  Siemens plc 2014 All Rights Reserved
5.6.5 Side Access Configuration Dip Switch Settings
Note: Default settings are with all DIP switches set to ‘0’/ OFF.
Configuration DIP Switch Number
1 2 3 4 5 6 7 8
Detection Direction
0,0 = Detects pedestrians moving in
both directions (default)
0,1 = Detects pedestrians moving
away from unit only
1,0 = Detects pedestrians moving
towards unit only
1,1 = As per 0,0
Detector LED
0,0 = Normal Detector O/P
0,1 = Permanently Off
1,0 = Detector O/P for 20 minutes
after power applied
1,1 = Normal Detector O/P
Detector Hold
Time
0 = 600mS
1 = 2000mS
Detection
Sensitivity
0 = Normal
1 = High
DFM
0 = Default
monitor time
(20 hours
inactivity)
1 = ‘fault monitor
time’ is set by the
Engineer’s
Terminal
Remote
Configuration
0 = Disabled
1 = Enabled
Note: Some DIP switches may be marked with ON/OFF. For the purposes of definition, OFF is equal to 0 and ON is equal to 1.
Table 5-24 – Pedestrian On Crossing Configuration Switch Settings
Refer to section 6 for detailed information regarding final commissioning.