Specifications

Siemens Mobility, Traffic Solutions

Sopers Lane, Poole, Dorset

BH17 7ER

Version 10 Page 22 of 120 Status Issued

Last Editor harry.smyth Date 03 November 2014

Document

Name

GENERAL HANDBOOK FOR HEIMDALL

DETECTORS

Doc. No. 667/HB/31900/000

4 GENERAL INSTALLATION INSTRUCTIONS

4.1 General Introduction

This section outlines the general information required when installing a Heimdall Above

Ground detector.

4.2 Tools Required

As well as a standard Installers tool kit, the following are required when installing and

maintaining the Heimdall Detector:

 1.5mm Allen key – for side access door and lid.

 T-8 Torx driver – alternative tool for side access door and lid.

 13mm Socket spanner – for angular adjustment and installation of detector.

 Small flat bladed screwdriver – for DIP switch adjustment.

4.3 Order of Installation

The recommended order in which installation should take place is as follows:

(1) Read the Safety Warning on page 2 of this Handbook.

(2) Unpack items from packaging (reference section 4.4).

(3) Set configuration DIP switches (in most cases the detectors will be supplied ready to

fit, if it is required change these settings then consult appropriate detector

requirements in section 5).

(4) Fit Detector to appropriate mounting structure (refer to appropriate detector

requirements – reference section 5).

(5) Perform initial Detector Alignment (refer to appropriate detector requirements –

reference section 5).

(6) Connect detector to bulkhead mating connector.

(7) Final commissioning (section 6).