Operating instructions

e1955
11.1999
38
Siemens Building Technologies
Cerberus Division
Overview operating menus
cont.
To enter ’MAIN MENU’ press
F2
FUNCTION LIST ’area’
switching MANNED/UNMANNED
poll COUNTER ’fire alarms’
reset COUNTER ’fire alarms’
poll COUNTER ’remote alarms’
DE–ISOLATE alarm HORN
ISOLATE alarm HORN
alarm HORN –> START
alarm HORN –> STOP
initiate TEST alarm HORN
DE–ISOLATE REMOTE transm. ’fire’
ISOLATE REMOTE transm. ’fire’
DE–ISOLATE REMOTE transm. ’others’
ISOLATE REMOTE transm. ’others’
DE–ISOLATE REMOTE transm. ’fault’
ISOLATE REMOTE transm. ’fault’
poll EVENT MEMORY
FUNCTION LIST ’section’
ISOLATE all ZONES
DE–ISOLATE all ZONES
FUNCTION LIST ’zone’
ISOLATE zone
DE–ISOLATE zone
ACTIVATE zone
DEACTIVATE zone
FUNCTION LIST ’element’
poll INFORMATION ’element’
DISCONNECT element
CONNECT element
ACTIVATE element
DEACTIVATE element
AREAS...
ZONES...
ELEMENTS...
ok
ok
ok
ok
F1
F1
F1
F1
F1
Note
F1 = press
ok = press
FUNCTION LIST ’event memory’
poll all messages
poll all DANGER messages
poll all FAULT messages
poll all DISCONNECTION messages
poll all INFORMATION messages
poll all TEST-ALARM messages
ok
F1
ok
SECTIONS...
control in–/outputs
Note:
for time channels no function available
MAIN MENU
FIRE detection
EXTINGUISHING sections
CONTROL in- /outputs
GEOGRAPHICAL location
DEVICE level
logical address (CSX no.)
access level 3 ’service’
access level 3 ’service’
ok:select F1:function C:end
FUNCTION LIST ’installation’
set CLOCK
set DATE
re-configuration C-bus
acknowledge all
reset all