Operating instructions

e1955
11.1999
37
Siemens Building Technologies
Cerberus Division
Overview operating menus
cont.
To enter ’MAIN MENU’ press
F2
FUNCTION LIST ’area’
switching MANNED/UNMANNED
poll COUNTER ’fire alarms’
reset COUNTER ’fire alarms’
poll COUNTER ’remote alarms’
DE–ISOLATE alarm HORN
ISOLATE alarm HORN
alarm HORN –> START
alarm HORN –> STOP
initiate TEST alarm HORN
DE–ISOLATE REMOTE transm. ’fire’
ISOLATE REMOTE transm. ’fire’
DE–ISOLATE REMOTE transm. ’others’
ISOLATE REMOTE transm. ’others’
DE–ISOLATE REMOTE transm. ’fault’
ISOLATE REMOTE transm. ’fault’
poll EVENT MEMORY
FUNCTION LIST ’section’
BLOCKING autom.extinguishing
ENABLING autom.extinguishing
BLOCKING autom.& man. extinguishing release
ENABLING autom.& man. extinguishing release
ISOLATE all DETECTOR zones
DE–ISOLATE all DETECTOR zones
set all DETECTOR zones –> TEST
terminate TEST of all DETECTOR zones
set all DETECTOR zones –>INSTALL: TEST
terminate INSTALL.TEST of all DET. zones
set extinguishing control –> REVISION
terminate REVISION
set extinguishing control –> TEST
terminate TEST of exting. control
initiate TEST ”horn”
initiate TEST ”warning panel”
AREAS...
ZONES...
ok
ok
ok
ok
F1
F1
F1
F1
Note
F1 = press
ok = press
FUNCTION LIST ’event memory’
poll all messages
poll all DANGER messages
poll all FAULT messages
poll all DISCONNECTION messages
poll all INFORMATION messages
poll all TEST-ALARM messages
ok
F1
ok
SECTIONS...
EXTINGUISHING sections (details see document e1956)
FUNCTION LIST ’element’
poll INFORMATION ’element’
ISOLATE element
DE–ISOLATE element
ACTIVATE element
DEACTIVATE element
CHANGE
parameter set
parameter set -> DEFAULT
ELEMENTS...
F1
see document e1957
MAIN MENU
FIRE section
EXTINGUISHING sections
CONTROL in- /outputs
GEOGRAPHICAL location
DEVICE level
logical address (CSX no.)
see document e1956
FUNCTION LIST ’zone’
ISOLATE zone
DE–ISOLATE zone
set zone –> TEST
set zone –> TEST OFF
activate FAULT TEST
set zone –> RENOVATION
set zone –> RENOVATION OFF
ACTIVATE zone
set zone –> INSTALLATION TEST
set zone –> INSTALLATION TEST OFF
access level 3 ’service’
access level 3 ’service’
access level 3 ’service’
ok:select F1:function C:end
FUNCTION LIST ’installation’
set CLOCK
set DATE
re-configuration C-bus
acknowledge all
reset all