Operating instructions

e1955
11.1999
36
Siemens Building Technologies
Cerberus Division
Overview operating menus
To enter ’MAIN MENU’ press
F2
FUNCTION LIST ’area’
switching MANNED/UNMANNED
poll COUNTER ’fire alarms’
reset COUNTER ’fire alarms’
poll COUNTER ’remote alarms’
DE–ISOLATE alarm HORNS
ISOLATE alarm HORNS
alarm HORN –> START
alarm HORN –> STOP
initiate TEST alarm HORN
DE–ISOLATE REMOTE transm. ’fire’
ISOLATE REMOTE transm. ’fire’
DE–ISOLATE REMOTE transm. ’others’
ISOLATE REMOTE transm. ’others’
DE–ISOLATE REMOTE transm. ’fault’
ISOLATE REMOTE transm. ’fault’
poll EVENT MEMORY
FUNCTION LIST ’section’
ISOLATE all DETECTOR zones
DE–ISOLATE all DETECTOR zones
ISOLATE all CALL POINT zones
DE–ISOLATE all CALL POINT zones
set all DETECTOR zones –> TEST
terminate TEST of all DETECTOR zones
set all CALL POINT zones –> TEST
terminate TEST of all CALL POINT zones
set all DETECTOR ZONES –> INSTALL. TEST
terminate INSTALL.TEST of all DET.zones
FUNCTION LIST ’zone’
ISOLATE zone
DE–ISOLATE zone
set zone –> TEST
set zone –> TEST OFF
activate FAULT TEST
set zone –> RENOVATION
set zone –> RENOVATION OFF
ACTIVATE zone
set zone –> INSTALLATION TEST
set zone –> INSTALLATION TEST OFF
FUNCTION LIST ’element’
poll INFORMATION ’element’
ISOLATE element
DE–ISOLATE element
ACTIVATE element
DEACTIVATE element
CHANGE
parameter set
parameter set -> DEFAULT
AREAS...
ZONES...
ELEMENTS...
ok
ok
ok
ok
F1
F1
F1
F1
F1
Note
F1 = press
ok = press
FUNCTION LIST ’installation’
set CLOCK
set DATE
re-configuration C-bus
acknowledge all
reset all
FUNCTION LIST ’event memory’
poll all messages
poll all DANGER messages
poll all FAULT messages
poll all DISCONNECTION messages
poll all INFORMATION messages
poll all TEST-ALARM messages
ok
F1
ok
SECTIONS...
select FIRE section
see document e1957
MAIN MENU
FIRE detection
EXTINGUISHING sections
CONTROL in- /outputs
GEOGRAPHICAL location
DEVICE level
logical address (CSX no.)
ok:select F1:function C:end
access level 3 ’service’
access level 3 ’service’