Operating instructions

e1955
11.1999
35
Siemens Building Technologies
Cerberus Division
Set clock and date
Normally the date and time do not have to be corrected!
The date and time are set by the service engineer when installing the system.
 The summer/winter time changeover is performed automatically.
 Time and date are always displayed when the password is entered.
Setting the clock
1. Press
F2
Ü The MAIN MENU is displayed
2. Press
F1
Ü The FUNCTION LIST ’installation’ is displayed
3. Press
ok
Ü An input prompt is displayed
Enter the current time and press
ok
(2 digits each for hours / minutes / seconds)
Ü The new time is read in and loaded
Setting the date
1. Press
F2
Ü The MAIN MENU is displayed
2. Press
F1
Ü The FUNCTION LIST ’installation’ is displayed
Press
to select the function «set DATE»
3. Press
ok
Ü An input prompt is displayed
Enter the current date and press
ok
(2 digits each for day / month / year)
Ü The new date is read in and loaded
MAIN MENU
FIRE detection
EXTINGUISHING sections
CONTROL in- /outputs
GEOGRAPHICAL location
DEVICE level
logical address (CSX no.)
FUNCTION LIST ’installation’:
re-configuration C-bus
SET CLOCK
FUNCTION LIST ’installation’:
set CLOCK
set CLOCK
set DATE
HHMMSS
set DATE
re-configuration C-bus
SET DATE
DDMMYY
ok:select F1:function C:end
ok:execute F1:menu C:end
0..9,del:edit ok:set C:cancel
ok:execute F1:menu C:end
0..9,del:edit ok:set C:cancel
MAIN MENU
FIRE detection
EXTINGUISHING sections
CONTROL in- /outputs
GEOGRAPHICAL location
DEVICE level
logical address (CSX no.)
ok:select F1:function C:end