User's Manual

User Manual for AyAlarm AyTerminal
V2.1 AyAlarm application
Triggers
Temperature
Activation delay
Triggers
Temperat
Activation
Figure 5-36 Setup triggers menu for Temperature watchdog mode
In case of the Voice Call mode the user has the possibility to define a phone number where to call
instead of the “Triggers” option (see Figure 5-37). The phone number is the actual set phone
number (e.g. [phone]). If the phone number is not defined then the “<Enter Nr.>” line will
be displayed in the menu.
Voice Call
Start
Activation time
Autostart
Notifiers
Voice Call
<Phone numbe
Overview
Start
Activation time
Voice Call
Start
Autostart
Activation
Voice Call
Notifiers
Overview
Start
Figure 5-37 Settings menu in Voice Call mode
Also the overview screen contains different data than for the other modes (see 5.4.6).
Each trigger can be activated/ deactivated if it is not the only one defined for that mode.
Each trigger has its own list of parameters to be set. At least one alarm trigger has to be activated
when the mode is started.
It is defined that if there is only one trigger per mode then that trigger is automatically activated.
To set a sensor threshold value one of the sensor calibration screens will be shown. This screen
contains the following information:
• Currently measured sensor value
• Current threshold value
• Additional text to describe the shown values (see Figure 5-38)
See each sensor description to see value range.
Generic screens:
<sensor>
<text 1> +24 t2
t3
+35
t2
v1
<t1>
v2
<sensor>
Examples in jumbo mode: