User's Manual

User Manual for AyAlarm AyTerminal
V2.1 AyAlarm application
Charging
finished
Charging
finished
Charging
Interrupted
Charging
interrupted
Figure 3-6 Charging possible states of AyTerminal
3.1.11.2Connecting a charger & AyTerminal switched on
If the device is switched on and a charger is connected, the charging battery symbol will be shown
while the status bar is shown. The AyTerminal will work normally like it does without charger
connected.
Alarm Clock
Baggage Secure
Room Monitor
Car Alarm
Alarm Cloc
Baggage S
Room Mon
Figure 3-7 AyTerminal ON in charging mode
3.1.11.3Charger connected, AyTerminal running, shutting down
If the changer is connected while AyTerminal is switched on and user selects Turn Off in main
menu, shutting down procedure is started – see the chapter 5.9, and the AyTerminal pass in
charging state. A screen like in Figure 3-6 is shown. If after this screen is shown the charger is
removed then AyTerminal is turned off. The AyTerminal can be turned on again by pressing long
the central button.
3.1.11.4Connecting charger before shutting down AyTerminal
If after connecting the charger Turn Off item is selected in main menu the AyTerminal is executing
a turning off procedure (see the chapter 5.9). While AyTerminal is turning off and the charger is
connected then AyTerminal will enter in charging state and a screen like in Figure 3-6 is shown.
NOTE: Do NOT connect charger while TURNING OFF the AyTerminal because the data that is being
saved might be corrupted!
4Installation and startup
4.1Installation
Remove the battery cover by pressing the Release button (see Figure 3-3). Slide the SIM card into
its holder. Make sure that the gold contacts of the SIM are facing down and the cut off corner is
correctly aligned. Insert the battery side way into the AyTerminal and then press it downwards until
it clicks into position. Place the battery cover back.