User's Manual

User Manual for AyCare AyTerminal
V2.1 AyCare application
GREEN permanent AyTerminal ON, startup phase
ORANGE /
GREEN
blinking (500msec
ORANGE, 500msec
GREEN)
AyTerminal ON, startup phase, firmware
update
GREEN /
BLACK
blinking (100msec
ON, 2000msec OFF)
AyTerminal ON, mode active or idle
ORANGE /
BLACK
blinking (100msec
ON, 2000msec OFF)
AyTerminal ON, shutdown phase
(selection of Turn OFF item)
GREEN /
BLACK
blinking (100msec
ON, 200msec OFF)
AyTerminal ON, GPRS/SMS/GSM
transmission
•
RED /
BLACK
blinking (300msec
ON, 300msec OFF)
AyTerminal ON, error indication like:
• low battery,
• to many AySnapOn´s connected,
no SIM inserted
ORANGE /
BLACK
blinking (300msec
ON, 300msec OFF)
AyTerminal ON, AyApplication alarm is
triggered
RED permanent AyTerminal ON, critical error, device
deactivation after 15min
Table 2-2 Status LED colors depending on AyTerminal status
In case of two or more simultaneous events that can trigger the change of Status LED color there
have been established priority rules.
These rules are:
1. If the Status LED color is blinking ORANGE or RED then the Status LED color can not be
changed to GREEN (permanent/ blinking slow/ blinking fast). In this case the status LED
ORANGE/ RED must be first stopped and after that the status can be changed to GREEN
(permanent/ blinking slow/ blinking fast) or the change request for GREEN can be
performed but the status will be changed only when ORANGE/ RED will be turned off.
2. Permanent/ Fast/ Slow RED LED status can be set no matter the current LED status
3. If the status LED color is blinking RED then the Status LED color can not be changed to
ORANGE (permanent/ slow/ fast). In this case the status LED RED must be first stopped
and after that the status can be changed to ORANGE (permanent/ blinking slow/ blinking
fast) or the change request for ORANGE can be performed but the status will be changed
only when RED will be turned off.
4. In case of turning off one status LED the previous status LED is set back (e.g. Previous
status is slow GREEN and current status permanent RED. When the status RED is
removed then the slow GREEN is again established as status of the LED)
Example of applying the rules:
In case of triggering an alarm it is defined that the status LED becomes fast blinking ORANGE.
In case of SMS it is defined that the status LED is blinking GREEN. If SMS is sent meanwhile
the alarm is triggered then the change request for status LED GREEN is stored but the status
is changed only when ORANGE is turned off (rule number 1).
2.1.3Lumberg connector
Using this 12 pin slim Lumberg connector is possible to:
Page 9 / 50