User's Manual

AyTerminal User Manual for AyCare
Contents V2.1
Figure 2-3 Release button
Figure 2-4 Hold-switch
2.1.1Hold-switch
This switch prevents unintended button presses, see Figure 2-4. A button press is accepted only in
case the switch is in position “unlock”. If the hold-switch is in position “lock“ the only accepted
action is the long-press onto the central button, if this is enabled by AyApplication e.g. to enable
emergency calls.
If the AyTerminal is off, the hold-switch on “lock” and long press is performed the AyTerminal will
NOT turn on.
2.1.2Status LED
This status LED is used to provide feedback to the end-user about the current AyTerminal status.
The dual-color LED is able to show the following colors:
• BLACK (off),
• GREEN,
• RED,
• ORANGE (mixture between red and green).
The LED is able to blink within the range from once per 25 seconds (0,04Hz) to 10 times per
second (10Hz).
Following table shows the status of the Status LED depending on the AyTerminal status.
Status LED
color type
AyTerminal status
GREEN permanent AyTerminal OFF, charger connected,
battery charging mode
RED permanent AyTerminal OFF, charger connected,
battery charging error
ORANGE permanent AyTerminal OFF, charger connected,
battery charging finished
Page 8 / 50
Release button
Hold-switch