User's Manual

User Manual for AyCare AyTerminal
V2.1 AyCare application
Baby Phone
Active
Baby Phone
Active
Figure 4-43 Active mode status screen for Baby Phone mode
After starting a mode a screen like in Figure 4-44 is shown in following cases:
• if the mode was started and the activation time’s active option was checked and the start
time is not encountered.
• if the activation time is active but the end time has been reached.
Baby Phone
Idle
Baby Phone
Idle
Figure 4-44 Inactive mode status screen for Car Alarm mode
The following data are shown in this screen:
• AyTerminal Status bar
• Mode’s name
• Active/Idle status
While a mode is started the green LED will blink.
In these screens only the deactivation code is available.
If an alarm is triggered a message will be displayed informing the user about the triggered alarm
(see Figure 4-45). In case that the alarm was triggered because the current value of a sensor
exceeded the set threshold the first displayed line contains the mode name and the second line the
pair sensor name – sensor value. The sensor name is the name of the sensor for which the value
was exceeded and the sensor value is the value of the sensor in the moment when the value was
exceeded. With the sensor value the measurement unit is also displayed (% for noise and ego-
motion sensors and °C for temperature sensor). This is the case of Baby Phone which has as
trigger noise sensor. If the alarm was triggered but no sensor was involved then the second
displayed line is replaced by the text “Alarm!”. This is the case of Leaving Location, Tracking Mode,
Voice Call and Panic Button where the alarm is not triggered by a sensor. The screen is updated
whenever something changes on AyTerminal (e.g call phone established, call phone ended). After
alarm duration the mode returns in Active state which is indicated on display.
<mode name>
<sensor>=<v
<mode nam
<s>=<valu
Page 37 / 50