User's Manual

AyTerminal User Manual for AyCare
Contents V2.1
Baby phone
Triggers:
Noise-
Activation
delay:30s
Notifiers:
SMS
([phone]),
AyServer
Duration:180s
Baby
phone
Triggers:
Activation
delay:30s
Notifiers:
Figure 4-42 Overview screen
The overview screen contains the following data:
• List of active triggers. For each trigger the threshold value is displayed.
• List of active notifiers, separated by commas. If a phone number for SMS or Voice Call is
defined the phone number is displayed in brackets.
• Alarm duration (if mode is defined to have it)
• Activation delay (if mode is defined to have it)
Example of displayed data (“Baby Phone” menu with SMS and AyServer as active notifiers and
with defined time):
“Notifiers: SMS ([phone]), AyServer”.
The text is wrapped and the screen’s content is scrollable using the up/down navigation buttons.
In case of “Voice Call” and “Panic Button” mode, the “Triggers” item is replaced by the “Phone
number” menu item. Therefore the Overview screen contains different data:
• The set phone number(s) where the voice call will be made
• List of active notifiers, separated by comma
Using the left button (Back) the previous screen is shown (Mode menu).
If the information is not fitting in one screen (one screen has 20 lines in standard and also jumbo
mode) then the text is split in more message boxes. Going from one message box to another is
possible by pressing the OK button.
4.5Activating/Starting a mode
A configured mode can be started by choosing “Start” in the mode menu. If the Activation time is
checked the mode is first going in idle status and will be activated at the user-specified time. Else
the mode is activated immediately after the “Start” option is chosen.
After starting a mode or starting the AyTerminal with the PIN of the SIM card disabled and the
mode set to auto start, a screen like in Figure 4-43 is shown in following cases:
• if the mode was started without activating the activation time option. In this case the mode
is started and also activated.
• if the mode was started and the activation time’s active option was checked and the start
time was encountered.
Page 36 / 50